Ustadj
November 26th, 2007, 21:15
It tookme a month to acquire a shell for my GP30 launcher until I settled for a CA m203 shell.
externally, the finish was quite nice and the built was quite sturdy...
but when I opened the shell... to my horror, the 4 holes where the ball bearing thingies are located ( I guess ball valve to) are not that cleanly made. I also noticed the crappy gasket that lines up the shell's "primer." I was crappy indeed that I had to replace it with an O-ring.
after being used for just 1 shot, to my horror, the O-ring for the part where the bearings were located was worn off. I had to manually improve its seal using the same technique that I use to seal cylinder heads for AEGs.
overall assessment.............it was quite disappointing... I don't think it will be able to hold red gas. to those who had used red gas, any info about its pros and cons? ;D thanks.
externally, the finish was quite nice and the built was quite sturdy...
but when I opened the shell... to my horror, the 4 holes where the ball bearing thingies are located ( I guess ball valve to) are not that cleanly made. I also noticed the crappy gasket that lines up the shell's "primer." I was crappy indeed that I had to replace it with an O-ring.
after being used for just 1 shot, to my horror, the O-ring for the part where the bearings were located was worn off. I had to manually improve its seal using the same technique that I use to seal cylinder heads for AEGs.
overall assessment.............it was quite disappointing... I don't think it will be able to hold red gas. to those who had used red gas, any info about its pros and cons? ;D thanks.