PDA

View Full Version : help! we m1911 gas leak

hitme
October 22nd, 2007, 18:52
anyone there who can advice on how to fix this problem? tnx:(
allanfig
October 24th, 2007, 06:10
use teflon tape :)
City Hunter
October 24th, 2007, 10:29
If yun nasa ilalim ng magazine ang may leak check mo yun o-ring. Be very careful in taking it out as yun ibang airsoft malambot na bakal ang gamit kaya use the proper tool o yun mag fit ng maayos. Don't force it kung mukhang hindi pwede. You could use the o-ring from the disposable lighters at tama, lagyan mo rin ng konting teflon tape for good airtight seal.
icarus
October 24th, 2007, 20:07
kung input valve, yun nilalagyan ng gas, remove the valve > soak the o-ring in silicon oil [couple of hours or more is better para lumambot at mamaga konti], and yes, wrap around about 2-3 single layer of Teflon in the valve thread
choybuts
October 24th, 2007, 23:17
If yun nasa ilalim ng magazine ang may leak check mo yun o-ring. Be very careful in taking it out as yun ibang airsoft malambot na bakal ang gamit kaya use the proper tool o yun mag fit ng maayos. Don't force it kung mukhang hindi pwede. You could use the o-ring from the disposable lighters at tama, lagyan mo rin ng konting teflon tape for good airtight seal.

Kung un Sa flow valve use the other oring sa may main nut sa ilalim pagpalitin mo.. or kung anytime and it probobly will masisira un oring on flow valve kunin mo un nsa ilalim na oring and change it to madaming ikot ng teflon.. BTW mahirap maghanap ng oring for gbb mazine.. Lighter oring doesnt work properly it will ruin ur gas cycle or eventualy sisingaw din..
hitme
October 26th, 2007, 18:32
tnx for all the help guys. one more thing, papano pala baklasin ung ilalim ng mag? un b ung 2 pin na nakatusok sa side?
hitme
November 2nd, 2007, 10:11
Naayos ko na rin at last.:) Just like to input some data in case others might encounter same problem. Don't use hammer wen rmoving d pin f d mag, just try to push it from d side kung san mdyo nkalubog ung pin. may ulo kc s kbilang side at hindi un lalabas kung s wrong side of d pin mo itutulak. den may mkikita kng square oil seal(plagay ko un ung nag leak sa akn), tnanggal ko un den inikutan ko ng konting teflon ung slot kung san un nkalagay pra umalsa ng konti ung rubber seal. mdyo sumikip un nung binalik ko at nwala n totally ung leak. Sinabay ko n rin ung thread s input valve(lagyan ng teflon) pra isang bukasan n lang.:D Hope i can help, d tulad ng nbilhan ko na gunsmith p nman, d man lang ako natulungan. :mad: