safety sear problem

[jimmiroquai]

Hi. I have a custom bolt handle installed on my Bar10/Kar98 hybrid and i occasionally have problems with the safety sear. Sometimes, it doesn't pop back up enough so i can't pull the trigger. Is it safe to sand this piece down or to remove it all together? How can i fix the problem? Does edgi make a replacement?

It's this piece:


The custom bolt handle:

[llawliet]

sir paki check baka nagstock up yun safety sear. yun sa akin kasi dati nag ganyan, ang ginawa ni edgi, niliha lang ng kaunti yun safety sear.

note: bar10g yun sa akin.. di po ako nagpacustomize ng bolt handle.

[jimmiroquai]

Yes, that's exactly what happens with mine. Anong part ng safety sear yung niliha?

[llawliet]

yun sa 1st pic sir yun me bilog, yun nakausling bakal na nagtutulak sa spring sir, yun ang niliha para numipis.

[alwe17]

mga sir . . meron din po akong problem . . pag-nag-slam-firing yung bar10 po . . . sa sears po ba yung problem ? o yung piston? tnx po

[P90_2013]

it was sear problem, sear doesn't locked up the piston... try to check the reversal spring that holds the sear, align it properly.. or your bar10 sear is already deformed

[libra]

Originally Posted by alwe17

mga sir . . meron din po akong problem . . pag-nag-slam-firing yung bar10 po . . . sa sears po ba yung problem ? o yung piston? tnx po

http://www.filairsoft.com/forum/showthread.php?t=75773

sir check this thread out.. try reading from first post to last.. anjan n po lahat ng mga possible problem kung bakit nagsSlam fire ang Bar-10.

[little 1]

doc, you could remove the piece all together but there is a chance of premature firing while cocking if the trigger is accidentally pressed...which is remote anyways because you are right handed....

try also looking at the engagement notch between the modified handle and the sear...there is a big tendency that the handle is leaving it depressed...and that is the reason that you cannot pull the trigger

try also to replace the spring it must not be popping as designed... txt or call so we could discuss lengthly..

[jimmiroquai]

Thanks, little_1! I ended up cutting a groove in the modified bolt handle for the sear to pop into.